What Was Announced
The ET1 is a scrubber-dryer robot that combines sweeping, scrubbing, vacuuming and dust-mopping in a single body. It uses a front-sweep, rear-scrub layout, which picks up dry debris and wet stains in the same pass.
The model sits below Pudu's existing cleaning family in a smaller body class. The manufacturer positioned it as a separate line, the E Series.
Technical Data Published by the Manufacturer
| Measure | Value |
|---|---|
| Body (L × W × H) | 500 × 380 × 580 mm |
| Weight | 45 kg |
| Target area | 100-800 m² |
| Throughput | 300-720 m²/h |
| Cleaning width | Scrub 30 cm, sweep 39 cm |
| Suction | Up to 20 kPa |
| Water capacity | 8 L clean / 7.2 L waste |
| Dust bin | 2.5 L |
| Battery | 35 Ah, 2.5-4 h run-time |
| Charging time | About 3 hours |
| Maximum speed | 1.0 m/s |
| Minimum clearance | 50 cm wide, 60 cm high |
These are the manufacturer's published figures. The throughput range varies by cleaning mode; the upper bound is not reached on heavily soiled or furnished floors.
Why a Separate Series
Pudu's existing cleaning models run larger bodies and higher hourly throughput, which pays off on wide, open floors. What sets the ET1 apart is dimensional: a 380 mm body and a 50 cm clearance limit determine how much of a tightly laid-out floor the robot can actually reach.
If the narrowest passage in a facility is under 60 cm, a larger machine skips those aisles and they keep being cleaned by hand. That is also where the saving leaks away. This is precisely the band the ET1 targets.
Venues the Manufacturer Targets
Pudu lists the target venues for the ET1 as convenience stores, drugstores, chain restaurants, business and economy hotels, and office floors.
What they share is layout rather than size: floors where narrow passages between shelving, tables and reception areas are the limiting factor.
Availability in Turkey
Robotlar.org is the official Turkey partner of Pudu Robotics. No starting price has been published for the ET1 yet; a quote is prepared once floor area and use case are settled.
The first measurement that decides whether the model fits your facility is the width of your three narrowest passages. Send us those figures and we can assess suitability before a quote is issued.